Skip to content
Farmcoat
Spend €918,05 more for FREE shipping.
FREE shipping will be applied at checkout
Agricultural Epoxy Floor Coating €81,95
5 KG / Grey (RAL 7001)
1 Cart ( €81,95 )

Preparing a concrete floor for coating

A high-quality floor coating does not start with applying the coating, but with the proper preparation of the substrate. Professionally pre-treating a concrete floor ensures optimal adhesion, prevents problems, and extends the lifespan of your floor.

Why is pre-treatment so important?

Without proper preparation, even the best coating can fail. At first glance, concrete may appear solid and even, but both new and existing concrete have a top layer that is less suitable for direct coating. New concrete has a smooth cement skin that hinders the adhesion of the coating. Existing concrete may be contaminated, weakened, or damaged. In addition, imperfections in the concrete, such as protruding pebbles, can detract from the final result.

With the right pre-treatment, you can prevent these problems and ensure a smooth and durable final result.

Our method: step by step

1. Pressure washer

First, thoroughly clean the concrete with a pressure washer.

2. Grinding

Next, the concrete must be ground with a concrete grinder. For new concrete, this is done to roughen the surface and remove the cement skin. For existing concrete, grinding is necessary to remove weak or brittle parts and protruding pebbles. A ground surface ensures optimal adhesion.

This can be done with a concrete grinder. An alternative is the use of concrete grinding discs that can be mounted on an angle grinder.

On our website, we offer 125 mm and 180 mm discs. These are suitable for surfaces up to approximately 100 m². For larger surfaces, we recommend using a professional machine.

3. Cleaning with ADP cleaner

After grinding, the floor must be cleaned with Farmcoat ADP cleaner, diluted in a ratio of 1:10 with water. Allow it to work for a while, then rinse it off with clean water and dry the floor. Use a brush if necessary to work the product in properly.

4. Drying and coating

Next, allow the floor to dry thoroughly. If necessary, this can be assisted with a gas burner or hair dryer. Once the floor is completely dry, the coating of your choice can be applied.

The result: a strong foundation for coatings

A well-ground and cleaned concrete floor ensures:

  • Optimal adhesion of the coating
  • Longer lifespan of the system
  • A smoother and more even final result
  • Reduced risk of damage or peeling