Skip to content
Farmcoat
Spend €1.000 more for FREE shipping.
FREE shipping will be applied at checkout

Your cart is empty

Continue shopping
0 Cart ( €0,00 )

How do you apply an epoxy floor coating to a concrete floor yourself?

How to apply an epoxy floor coating to a concrete floor yourself?

Easy to apply in 1 day

Farmcoat Epoxy Floor Coating is very easy to apply yourself in 1 day. Here we explain how you can easily apply an epoxy floor coating to a concrete floor in your barn, tank room, feed room or garage floor.

Requirements

1. Preparation

The preparation process is of the utmost importance for a good end result. Grease, dirt
(feed residues/manure) and other contaminants must be completely removed from
the substrate. Use high pressure if necessary.

2. Sanding

Sand the substrate with a concrete grinder or concrete sander. This ensures long-lasting adhesion. On heavily worn substrates, sanding also smooths out unevenness, removes brittle/loose pieces and ultimately means you need less coating. Sanding is therefore also cost-saving! New trowelled floors must also be sanded. This is because they are so smooth/densely trowelled that the coating cannot adhere well to them. New concrete substrates that have not been trowelled and already have a rough surface do not need to be sanded (as in the instructional video on this page). Rinse the floor again after sanding to remove all dust.

3. Cleaning

Apply the Farmcoat ADP Cleaner diluted with water (1 to 10) to the floor using the sprayer with nozzle. Scrub it in and let it work on the floor for a maximum of 10 minutes. After 10 minutes, spray the substrate clean with tap water. The ADP Cleaner is an acidic cleaner that ensures all tiny dirt particles (invisible to the eye) dissolve. In addition, the ADP Cleaner ensures that the pores of the concrete open up. This makes the coating adhere even better!

4. Coating

Make sure the substrate is completely dry before you start coating. You can do this by letting it dry overnight or by forcing it with a gas burner. Tape the substrate where necessary for a good separation line (relevant for feed rooms).

Mix Farmcoat Epoxy Floor Coating before use by combining the B-component (hardener) with the A-component and mixing it thoroughly with the supplied mixing paddle on a drill for 2 min. Also mix well along the edges and over the bottom of the can.

Pour the coating out in parts on the floor within 30 minutes and spread it over the floor with a roller. Use the roller to spread/push forward the thick layer. Use the brush for the edges/corners. A squeegee can also be used if necessary. Note: stick to the working time. Outside the working time, the curing process of the products begins and the products become difficult to work with. Store the coating cool (< 20°C) before use. Do not leave in the sun.

5. Drying

After 12 hours of drying, you can use the floor again. 

Also watch our instructional video on the product pages.